Engineering tools
Two calculations we run on every project: what a duty point costs in shaft power, and what changes when a centrifugal pump is replaced by a plunger pump. Everything runs in your browser — no data is sent anywhere.
These are screening numbers, not a selection. They assume clean-fluid power with the efficiency you enter, and they ignore NPSH, viscosity correction and motor margin. A real selection adds a model-rating margin (+10% flow, +1 MPa) and then sizes the motor at ×1.10 of that shaft power — the same chain we use in our proposal system. The calculator shows both the duty point and the selection point.
The shaft power of a worn centrifugal pump is often 1.6–2× the new pump — not because the motor is oversized, but because efficiency has fallen away from the design point. Measured input power is the single most useful number you can give us.
Simple payback only. It ignores maintenance savings (typically 30–50% of the energy saving on abrasive duties), downtime and the residual value of the old unit — so the real payback is usually shorter than shown.